Tetrion Make Good Fix A Leak - 400ml

Rubberised protective proofing formula

Easy to use aerosol format

High build, tough, flexible

UV resistant

Seals fine leaks & cracks

Tetrion 'Make Good™' Fix a Leak is a liquid rubber in a can!  Tetrion Fix a Leak provides a rubberised coating which fills and seals fine leaks and cracks, it can also protect items and products from moisture and weathering. Tetrion Fix a Leak provides a tough, watertight yet flexible seal which can stop leaks on certain substrates. This seal withstands movements, wide temperature changes and bright sunlight meaning it is ideal to fix leaking pipes both indoors and out. The clear-drying and over-paintable finish ensures all fixed leaks are inconspicuous.

Fix a Leak can be used on roof lights, ducting, vinyl, plastic, metal, masonry concrete, plant pots, gutters and downspouts. It is UV resistant and can be overpainted. It works impressively in waterproofing surfaces, especially on surfaces that are in direct contact with seepage water, moisture and non-pressurised liquid or water.

400ml Aerosol

ADVANTAGES

• Rubberised protective proofing formula
• Easy to use aerosol format
• High build, tough, flexible
• UV resistant
• Seals fine leaks & cracks
• Low gloss finish

APPLICATION

• Remove all loose dirt & debris from the area to be coated. If required, clean and thoroughly dry the area
• Remove any previous surface coatings with a wire brush and abrasive paper
• Lightly sand with a finer abrasive paper to give a good key and re-clean & dry
• Shake aerosol can vigorously for 2 minutes minimum
• Firstly test spray on a small inconspicuous area, to check spray rate, pattern and compatibility
• Apply in short, even, light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry inbetween coats
• If spray button clogs, invert can and spray to release
• Clean overspray and spillages before coating dries, with white spirit-type solvent

AVAILABILITY

400ml - TFL400